Palazzetti Ecofire, Installation, User And Maintenance Manual, Page: 60 / 164

60/164 cod. 00 477 1480 - 12/2012 - Palazzetti - PN - Italy
USE AND MAINTENANCE
10.2 STANDBY FUNCTION
During operation (i.e. when the stove is on and in steady operating conditions) the stove can be switched off
when reaching the set room temperature (SET ROOM T.) and start again when reaching the set minimum room
temperature (START TEMP.).
To enable this function, go to the “STOVE SETTINGS MENU” following the “Procedure for accessing the menus”
described in paragraph 7.3 and press . Use the arrow buttons to scroll until the display shows “STAND-BY”
and then press .
Two parameters can be set:
j ' jX=£X||j
j ' !
When this function is active, the display shows the “ ” symbol.
“STAND-BY” is displayed when the room temperature is higher than the set “START TEMP.”.
10.3 FROST PROTECTION FUNCTION
When the stove is off this function ensures the stove maintains the set room temperature (useful at night).
To access this function go to the “STOVE SETTINGS MENU” using the “Procedure for accessing the menus”
described in paragraph 7.3 and press . Use the arrow buttons to scroll the menu and select “NIGHT SET
T.” using the button.
'žš+X||<™
value (between 3° and 20°C) representing the temperature below which the stove will start.
When this function is active, the display shows the “ ” symbol.
“NIGHT STAND-BY” is displayed when the room temperature is higher than the set “NIGHT SET T”.
10.4 “ECONOMY” FUNCTION
This is used to set the stove’s maximum operating output in automatic mode. The set power level will never be
exceeded, thus keeping fuel consumption under control.
10.5 RESTARTING AFTER A POWER FAILURE
In the event of momentary power failures, the stove will restart automatically when power returns, if the conditions
!* ™šš+?›X#<
manually as described in chapter 12.
10.6 READING THE OPERATING HOURS
The display can show total stove operating hours or the number of hours remaining before recommended
maintenance is required (to be performed by the Service Centre).
Pressing and holding the button will display the TOTAL HOURS for a few moments, while pressing and holding
the button will display the REMAINING HOURS for a few moments.
10.7 PELLET LEVEL FUNCTION
The pellet stove is provided with a device for the detection of the reserve level of the pellet tank. When this value
is reached, the words ‘LOW PELLET’ will be displayed cyclically and an acoustic signal will be uttered.
Ÿ™ ›™™!
10.8 OPERATION WITH ROOM THERMOSTAT
After having connected the room thermostat, when this is activated the stove will go to the lowest power
level (minimum output) while otherwise maintaining standard operation. The display will show the message
+'¡&[–X\'#'X=<™šš !
10.9 “EASY CLEAN” FUNCTION
This function is used to clean the stove by reducing the amount of ash dispersed in the room.
” œ œ!
It can only be activated when the stove has cooled down completely and is off.
When the stove is OFF, press the
OFF
ƒ šœš
switch off automatically after a preset cycle).
To stop the operation manually, press the
OFF
button.