Palazzetti Ecofire Adagio, Installation, User And Maintenance Manual

Page: 51 / 136

cod. 00 477 2290 - 04/2015 - Palazzetti - PN - Italy 51
ENGLISH
USE AND MAINTENANCE
10.8 FROST PROTECTION FUNCTION
2QO\LQFRQ¿JXUDWLRQ
A minimum temperature can be set below which the stove will switch on (outside of the set time bands, and only
if the timer is active). To set the “frost protection” temperature:
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the button to select the password “7” and then press
WRFRQ¿UP
c) Select submenu
[9]
DQGFRQ¿UPE\SUHVVLQJ
;
d)
7KHYDOXHZLOOÀDVKFKDQJHLWXVLQJWKH
buttons (
OFF
;
3...20
°C);
e) Press
WRFRQ¿UPWKHVHWWLQJV
11 ALARM MANAGEMENT
If a malfunction occurs, the following procedure is activated:
1) audible alarm (beep);
2) one of the following system LEDs come on:
;
3) if the problem concerns an error, the stove will switch off.
Pressing and holding the “cancel” button shows the error code on the display:
ERROR/
WARNING CODE
DESCRIPTION POSSIBLE CAUSES LED
E001
Faulty control panel Control panel fault
E002
Remote control signal communication error Control panel fault
E004
Communication error
Connection cable between board and control panel
interrupted or detached.
,IWKLVDSSHDUVZKHQFKDQJLQJFRQ¿JXUDWLRQLJQRUH
the error
E101
Failed ignition error
No pellets
Pellet quality
Faulty ignition system
Burn pot dirty
Problems with the heating system
Problems with the pump
E105
Pellet probe malfunction Pellet probe disconnected or faulty
E108
*
Safety error Door or hopper lid open
E109
Pressure error or thermal safety
Flue gas exhaust system dirty
Seal gaskets worn
,QVXI¿FLHQWFRPEXVWLRQDLU
Problems with overheating in the pellet hopper
E110
Temperature probe malfunction Faulty air temperature probe
E111
Flue gas temperature probe malfunction
)DXOW\ÀXHJDVWHPSHUDWXUHSUREH
A001
Low pellet level
ico Q À as K i QJ
Pellets running out
A002
Scheduled maintenance warning
ico Q s À as K i QJ
The stove periodically requires maintenance to be
SHUIRUPHGE\DTXDOL¿HGWHFKQLFLDQ
A007
Pressure sensor malfunction
ico Q À as K i QJ
Pressure sensor or board fault.
----
Clean stove
&RPEXVWLRQFKDPEHUEXUQSRWRUÀXHJDVH[KDXVW
system dirty.
Pressure measuring tubes detached or blocked.
Combustion air intake blocked.
----
Failed ignition error
No pellets; Faulty ignition heater; Worn gaskets;
Incorrect burn pot position
* Only for the models equipped with safety microswitches on the door or on the hopper lid.
After having checked the type of message, the alarm can be reset by pressing the on/
off button
for a few moments.
If the error code is “
E109
”, before resetting the alarm, manually reset the thermostat
located on the rear of the stove (Fig. 11.1)
t K is s K o X ld E e carried o X t E\ a Q a X t K ori ] ed
tec KQ icia Q .
Then the stove can be started again.
¿J