Palazzetti Ecofire Adagio, Installation, User And Maintenance Manual

Page: 38 / 136

38 cod. 00 477 2290 - 04/2015 - Palazzetti - PN - Italy
INSTALLATION
“S
EALED
”
SERIES STOVES
The “Ermetica” series pellet stoves allow the
following possible installation alternatives:
‡
ducted combustion air using a coaxial pipe to
GLVFKDUJH WKH ÀXH JDV DQG WDNH LQ IUHVK DLU
consequently no fresh air vent is needed in the
room (Fig. 5.5 A, B=Air intake C, D=Flue gas
outlet);
‡
connect the stove combustion air intake to the
fresh air opening using a special pipe (Fig. 5.6).
5.5 FLUE GAS EXHAUST
The stove operates with negative pressure in the
FRPEXVWLRQ FKDPEHU DQG FRQVHTXHQWO\ WKH ÀXH
gas discharge must be airtight.
The stove must be connected to its own
VHSDUDWH ÀXH JDV H[KDXVW V\VWHP FDSDEOH RI
ensuring adequate atmospheric dispersion of the
combustion byproducts.
7KHFRPSRQHQWVPDNLQJXSWKHÀXHJDVH[KDXVW
V\VWHPPXVWEHVXLWDEOHIRUWKHVSHFL¿FRSHUDWLQJ
conditions and bear the CE mark.
7KHÀXHVVKRXOGEHVXLWDEO\LQVXODWHGHJXVLQJ
rock wool) or made using double wall steel pipes,
except for the initial vertical section inside the
room.
An initial vertical section measuring a minimum of
PHWUHVLVUHTXLUHGWRHQVXUHFRUUHFWÀXHJDV
exhaust.
There should be at least three changes in direction
DORQJ WKH ÀXH LQ DGGLWLRQ WR WKH ÀXH FRQQHFWLRQ
at the rear of the stove, using 45 or 90° angle
connectors or ‘T’ connectors.
Use always a ‘T’ connector with inspection cap on
DOOKRUL]RQWDORUYHUWLFDOFKDQJHVLQÀXHGLUHFWLRQ
It is necessary to connect a pipe at the bottom of the „T“
junction in order to discharge the smoke condensate
WKDWFRXOGIRUPLQWKHÀXHJDVH[KDXVW)LJD
The maximum length of horizontal sections is 2-3
PZLWKDQXSZDUGVVORSHRI)LJ
$QFKRUWKHÀXHVWRWKHZDOOXVLQJVSHFLDOFROODUV
7KHÀXHJDVH[KDXVWDWWDFKPHQW0867127%(
connected to:
‡
a chimney used by other heat generators
ERLOHUVVWRYHV¿UHSODFHVHWF
‡
air exhaust systems (range hoods, vents, etc.....)
even if these are ducted.
Shut-off or draught valves must not be used.
Combustion byproducts must be discharged
through the roof.
,I WKH ÀXH LV ORQJHU WKDQ PHWUHV DQG WKHUH LV
LQVXI¿FLHQW GUDXJKW PDQ\ FKDQJHV LQ GLUHFWLRQ
unsuitable discharge terminal, etc.) flue gas
exhaust may be less than optimum. In these cases,
WKHRSHUDWLQJSDUDPHWHUVZLOOQHHGWREHPRGL¿HG
ÀXHJDVH[KDXVWDQGSHOOHWORDGWRDGDSWWKHVWRYH
¿J ¿J
¿J
B
B
B
MAX 2 - 3 m
C > 3 - 5%
min 1,5 m
A
A D
B
C
Fig. 5.7a