Paladin Tools 1112 AM, Operation And Use Manual

Page: 26 / 34

5. Measure 1” from the tip
of the dielectric and
mark the cable jacket.
Using a firm twisting motion, insert the cable into
the connector until the mark on the cable jacket is
flush with the connector.
6. Install the cable/connector into the SealTite®
PRO crimper. The flat front edge of the head
should be set on #10.
25
3. Flare the shield braid away
from the dielectric.
Note: If using Quad Shield cable, peel & remove the
outer foil shield. Then flare the inner shield back
from the dielectric.
SealTite® BNC
Compression Connectors
1. If using the color code bands, slip onto the
cable and pull back out of your way while you
are preparing the cable.
Flare
Strip
2. Strip .25” through shield
braid & dielectric to the
center conductor & then
strip another .25” back
without piercing the braid.
4. Fold the shield braid back
over the cable.
Fold Back
Paladin Tools ®
➱
Insert Cable