Paladin Tools 1112 AM, Operation And Use Manual

Page: 7 / 34

Tool Operation and Use Guide 6
1240 Series CST (Coax) Strippers
To strip coaxial cable:
1. Make sure the blade cassette is installed in the
back section of the tool.
2. Fully retract the rollers by moving the cam switch
lever to the full, back position.
3. Push the locking slide on the bottom to the fully
advanced position.
4. Insert the cable into the side of the tool where the
arrow indicates.
5. Push the cam switch lever to the fully forward
position to lock the cable in place. Pull the locking
slide on bottom of tool back to set the cam.
6. Adjust the screws located on the back side of the
tool to position the blade cutting depths for each
stripping level (jacket, shield, inner dielectric
insulation).
7. Place your finger in the round hole & rotate the
tool around the cable clockwise in the direction of
the arrow.
8. Hold the cable with one hand & pull the tool out
away from the cable to strip.
9. Repeat the above steps until the proper cutting
depth is achieved.
Cam
Y-block
Adjustment
screws
Memory
cassette