Pack Mule PC NXG Series, Manual

Page: 26 / 50

20
LED
Code
Smart View
Fault Code
Fault
Category
Possible Cause Fault Clearance
13 F13101 1 This warning is set if any task has
between 10% and 20% of its stack
free
13 F13102 1 An internal logic supply rail has
gone out of range.
14 F14101 1 EMCY message received from
non-Sevcon node and anonymous
EMCY level is set to 1. Check status of non-
Sevcon nodes on CANbus.
14 F14102 1
14 F14103 1
15 F15101 1 Vehicle service next due time has
expired (if supported). If support-
ed, service driveability profile will
activate. Service vehicle and reset
service hours counter.
2 F22001 2 Valid direction selected with oper-
ator not seated or operator is not
seated for a user configurable time
in driver. Must be seated with
switches inactive.
2 F22002 2 Both the forward and reverse
switches have been inactive simul-
taneously for greater than 200 ms. Check vehicle wiring and
reset switches.
2 F22003 2 FS1 active for user configurable
delay without a direction selected. Deselect FS1.
2 F22004 2 Any drive switch active at power
up. Deselect all drive switches
2 F22005 2 FS1 active after a direction change
and FS1 recycle function enabled. Deselect FS1.
2 F22006 2 Inch switch active along with any
drive switch active, seat switch
indicating operator present or
handbrake switch active.
2 F22007 2 Vehicle overloaded Remove overload condition
2 F22008* 2
2 F22009* 2
2 F22010 2 Traction function inhibited using
traction inhibit switch. Deselect traction inhibit.
2 F22011 2 Vehicle changed from traction
mode to pump mode (or vice-ver-
sa) when direction selected. Deselect all drive switches.
2 F22012* 2
2 F22013* 2
2 F22014 2 Fault with momentary direction
selection switch. Release momentary
direction switch
Fault Codes and Troubleshooting Chart (continued)