Pack Mule PC NXG Series, Manual

Page: 39 / 50

33
the User Mode, put the new PIN in twice and enter
each time. Example: Press 5 4 3 2 1 ENTER, and again
5 4 3 2 1 ENTER. The switch will give an indication
that the PIN was changed.
8 – Go out of Menu 1. Press CE. Press CE again to
Log Off the Supervisor Mode.
9 – Check out the new Supervisor PIN. Press 0 0
5 4 3 2 1 ENTER. You should be in Supervisor Mode.
You can now go to any menu by pressing the menu
number and ENTER.
Remember: This is an example. You should change
your Supervisor PIN to one known only to you.
10 – Determine Last User. While in Supervisor Mode
press 3 ENTER. This places you in the Last User Menu
as indicated by three red LED flashes. Press ENTER
again. The LED flashes will indicate the last user. The
Green LED is for the 10’s digit. The Red LED is for the
1’s digit. Example 1: A single Red LED flash indicates
User 01 last operated the vehicle. Example 2: Two
Green flashes and three Red flashes would indicate
User 23 last operated the vehicle. Press CE to leave
the menu.
11 – Enable or Disable Maintenance Alarm. Press 4
ENTER. There will be four red LED flashes. Press EN-
TER again. If the Green LED flashes, the alarm is en-
abled. Press ENTER again and the Red LED will flash
showing the alarm to be disabled. Press ENTER again
and the Green LED will flash showing the alarm to be
again enabled.
12 – Listen to the maintenance alarm. While in Menu
4 press 1 ENTER. The maintenance alarm will sound.
Press CE to leave the menu. Press CE again to Log
Off the Supervisor Mode.
Note: If the switch is left unattended in Supervisor
Mode, it will automatically exit the mode after ap-
proximately one minute.
13 – If you are unable to get into the Supervisor
Mode after trying either the default PIN or a newly
assigned PIN, go back to Step 1 and reset the switch.
If you need assistance or have questions about pro-
gramming or installing the SAFE-T-LOCK, call Tech
Support at 1-800-241-2869.