Pack Mule PC NXG Series, Manual

Page: 20 / 50

14
Onboard Battery Charger (continued)
If the detachable input power supply cord set
is damaged, replace with a cord that is: (for North
America) UL or CSA listed/approved detachable cord,
3 conductor, 16AWG minimum, and rated SJT; termi-
nating in a grounding type IEC 60320 C14 plug rat-
ed 250V, 13A minimum; or (for all other countries)
a safety approved detachable cord, 3 conductor,
1.5mm² minimum, rated appropriately for industrial
use. The cord set must be terminated on one end
with a grounding type input connector appropriate
for use in the country of destination and, on the other
end, an output grounding type IEC 60320 C14 plug.
Extension cords must be 3-wire cord no longer than
30m (100’) at 10AWG or 7.5m (25’) at 16AWG per UL
guidelines.
Connect only one charger to a single 15A circuit or
the circuit may become overloaded.
Charger enclosure may be hot during charging.
Use hand protection if handling the charger while
charging.
To prevent risk of electric shock, observe the fol-
lowing cautions:
Connect charger power cord to an outlet that has
been properly installed and grounded in accordance
with all local codes and ordinances. A grounded
outlet is required to reduce risk of electric shock.
Do not use ground adapters or modify the plug.
Do not touch uninsulated portion of output con-
nector or uninsulated battery terminals. Disconnect
the AC supply before making or breaking the con-
nections to the battery.
Do not open or disassemble charger. Do not op-
erate this charger if the AC supply cord is damaged
or if the charger has received a sharp blow, been
dropped, or otherwise damaged in any way. Refer
all repair work to the manufacturer or qualified per-
sonnel.
This appliance is not intended for use by persons
(including children) with reduced physical, senso-
ry or mental capabilities, or lack of experience and
knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance
by a person responsible for their safety.
If the optional single-LED display is included, it will be located on the front panel, near the key switch.
Optional Single LED Display