- 26 -
4-2. Speed selection contains 8 levels of labeling speed.
4-3. Key in value in “Missing Label” for the sensor to detect missing label.
4-4. Turn ON the “Missing label” after key-in of the value in the Missing label set, await the diagram
shows on display then function will start
※
※
※
※
:
If the missing label set is on, it must not indicate 0. Normally it is set at about 80% of the label
length. The machine will stop when there is a missing label on the label roll.
4-5. For the printer speed set icon, turn ON only when using printer.
Press “HOT STAMP PRINTER” icon for setting the required printing speed.
※
※
※
※
:
Printer speed setting, if the setting is long the speed will be slow. It depends on the transfer speed
the ribbon can tolerate. In setting the printing speed timing, the main consideration is the
ribbon’s transfer speed.
5.1 Memory store and read function; to save the present setting to the memory slots, go to the main
menu and select memory. Press save and assign a valid memory slot 0-30 to save the data. To
recall press read and the slot number, this will automatically load the data to the PLC.
Label length, position delay, batch counter/on/off, printer speed/on/off, missing label on/off, and
conveyor speed are saved and loaded as a set of parameters in each slot of memory.
Diagram 4
Diagram 5
Diagram 5
Summary of Contents for PL-622
