- 21 -
Top Hold Down Adjustment
1.
When adjusting the Top Hold Down, please put the bottle under the Top Hold Down, then adjust
the up/down hand wheel until the top hold down presses upon the bottle just enough to hold it.
This will maintain a stable labeling of the bottle.
Chain aligner Station Conveyor
Note:
1)
If pressure of the top hold down is loose, this will cause the bottle to be in a unstable condition
and the labels will not be applied on the right position
2)
If the top hold down is too tightly pressed against the bottle, this will cause the bottle to be
under heavy load. This condition is not good for the machine. .
3)
So in adjusting the top hold down, the pressure on the bottle must be just enough for it to pass
smoothly the sponge rollers.
Top Hold Down Belt
Bottle
Up/Down hand wheel
Summary of Contents for PL-622
