SECTION 4
OPERATION
53
4.6
SETUP MODE
SETUP MODE is used to:
Copy and Delete Programs
Copy, Edit, and Create Waveforms
Set Min. and Max. Voltage and Frequency Limits
Enable and Disable CSC (Continuous Self Calibration)
Set the Metering Sense Point
– Internal or External
Set Slew Rate and Transition Time
Set Transformer Ratio
Enable keyboard lockout
Set initial power-on output voltage
Monitor UPC and Power Source status
View Firmware Version
Enable Calibration Mode for Metering
Adjust LCD View Angle and Backlight Intensity
Set GPIB Device Address or Serial Interface Parameters
Erase Memory
Set Amps-to-Volts Current Metering Ratio
Define Current Transformer Location
Set Output Range - for power sources that support it
Display the Number of Power Source Amplifiers
Enable Current Protect Mode
Synthesize Waveforms from Harmonic values (Option)
Calibrate Programmable output impedance (Option)
Enable and Set Programmable Output Impedance (Option)
From any meter display, press the
fn
key to enter SETUP MODE.
SETUP MENU: 1 PROGRAM
2 WAVEFORM
3 GENERAL
4 CALIBRATION
NOTE:
Holding the
fn
key while applying power will bring up the SETUP MENU directly, with no Program
executing and no output. SETUP functions can be accessed as described below. Press CLEAR to exit
SETUP
, the UPC will indicate “NO PROGRAM RUNNING”. Select a PROGRAM and EXECUTE to initiate
normal operation and display the V/I screen.
4.6.1 PROGRAM SETUP
PROGRAM SETUP is used to copy and delete programs and erase memory.
From any METER display (V/I, AMPS or POWER), press the
fn
key to enter SETUP MODE.
From the SETUP display, press
1
to enter PROGRAM SETUP.
PROGRAM MENU:
1 COPY PROGRAM
2 DELETE PROGRAM
3 INITIALIZE PROGRAMS, WAVEFORMS, SETUP
