32
FRONT BRAKE
WARNING! Improper use of the front brake may cause front wheel to lock up
resulting in loss of directional control or rider being thrown over the handlebars.
Determine which type of brake your bike is equipped with and refer to the appropriate
assembly instructions below. *Additionally some freestyle models may be equipped
with a “cable detangler.” See assembly steps for cable detangler.
Caliper Brake
If the brake cable is not connected at the brake lever, slide the head of the brake cable
into the brake lever per the diagram, and thread the cable through the slot in the brake
lever so the cable end rests squarely in the adjustment barrel or cable end rests in the
recess of the brake lever (Fig. 3.16).
Brake adjustment
If the brake cable is disconnected at the caliper, thread the brake wire through the
adjustment barrel, loosen the cable anchor bolt until you can see a hole through the
anchor bolt for the cable wire to attach, thread the cable wire through the cable anchor
and snug the cable anchor by hand (Fig. 3.17).
Check to be sure the cable is seated in the brake lever. Loosen the cable anchor bolt
just enough to allow the cable wire to move freely. With your left hand squeeze the
caliper brake until both brake pads contact the rim. While holding the brake closed
with your left hand, use your right hand to pull the brake cable tight (through the
cable anchor) again inspecting that the cable end is seated in the brake lever, and
the adjustment barrel of the brake. Tighten the cable anchor as much as you can by
hand, and then while still squeezing the brake, tighten the cable anchor fully with
a wrench (Fig. 3.18).
WARNING! When assembling or adjusting the brakes, make sure the cable
anchor is tight. Failure to securely tighten the nut could result in brake failure
and personal injury.
WARNING! Do not lock up brakes. Sudden or excessive application of the
front brake may throw the rider over the handlebars, causing serious injury or
death. When braking, always apply the rear brake first, then the front.
ASSEMBL
Y
Adjustment barrel
Cable head
Brake Cable
Grip
Brake lever
Handlebar
Brake
arm
Center bolt
(fixing nut in back)
Cable
adjusng
barrel
Cable
anchor nut
Brake caliper
Brake shoe
3.16
3.17
3.18
32
