22
ASSEMBLY
1. Install a bearing into a planet gear and place a thrust
washer on each side of the gear. Position this assem-
bly into an opening in the carrier. Slide a planet gear
shaft through the carrier, thrust washer, bearing and
remaining thrust washer.
2. Carefully align the pin hole in the carrier with the hole
in the shaft and drive a new roll pin into place. AL-
WAYS use NEW roll pins.
3. The roll pin is slightly recessed into the carrier when
properly installed. With a center punch, stake the car-
rier next to the pin hole as shown. This will distort the
hole and prevent the pin from backing out in opera-
tion. Repeat these steps for each of the three planet
gears.
PRIMARY PLANET CARRIER
SERVICE
