3.
STARTING PROCEDURE
Before starting make sure machine is clear of materials
and all non-essential persons.
The machine is shipped without fuel & oil therefore you MUST fill the engine with fuel & oil before
starting the engine. Failure to do so will result in engine damage which will not be covered by warranty.
3.1.
Starting procedure. – from cold i.e. machine has not been run for some time.
Starting procedure for a COLD engine. Move the fuel tap to the ON position, Move the throttle lever to
mid position and the choke lever to the
START po
sition. Turn the engine switch ON. SLOWLY pull the
recoil
starter handle until you feel a resistance
t
hen pull firmly with
a smooth, steady motion to start.
Pull the handle
straight out to avoid excessive rope wear from the
starter rope guide.
Always pull in the
trigger gun when starting.
DO NOT let go of the recoil starter handle instead allow it to return gently. After the
engine starts slowly move the choke lever to the
RUN
position until the engine runs smoothly.
NOTE: To extend the life of the recoil starting rope periodically check its condition. If the rope is frayed,
have it replaced immediately.
NOTE - The choke position for starting may vary depending upon temperatures and other
factors. Once engine is running and warm, turn choke to the
RUN
position
Page 13
First edition -
April
201
7
The water must be turned on prior to starting the washer, pull the spray trigger to ensure water is
moving the through the lines and out the nozzle without any leaks before starting the unit.
Failure to
do this will result in damage to the seals which will not be covered under warranty
due to
overheating
