Starting procedure for a warm engine. Move the fuel tap to the ON position, Move the throttle lever to
mid position and the choke lever to the
RUN
position. Turn the engine switch ON. SLOWLY pull the
recoil starter handle until you feel a resistance then pull firmly with
a smooth steady motion to start.
P
ull the handle straight out to avoid excessive rope wear from the
starter rope guide. DO NOT let go of the recoil starter handle instead allow it to return gently.
NOTE: To extend the life of the recoil starting rope periodically check its condition. If the rope is frayed,
have it replaced immediately.
3.3. During use.
3.3.1. Under long, continuous-run operating conditions, be prepared to :
3.3.1.1. Check the fuel on a regular basis. DO NOT re-fuel when the engine is running or HOT.
3.3.1.2. Check engine oil level each time you refuel. See engine owner’s manual for more details.
3.3.1.3. Check pump oil level before each use.
3.2.
Starting procedure. – from warm i.e. machine has been run recently.
Page 14
First edition -
April
201
7
The water must be turned on prior to starting the washer, pull the spray trigger to ensure water is
moving the through the lines and out the nozzle without any leaks before starting the unit.
Failure to
do this will result in damage to the seals which will not be covered under warranty
