NEVER use chemicals or caustic liquids that cause bodily injury and/or property damage. You MUST
always follow the manufacturer’s advice and guidance on how to use detergents
5.2.4.1. To apply detergent, follow these steps: Fit black soap nozzle, prepare detergent
solution as required by job, place small filter end of detergent siphoning tube into detergent
container. NOTE: Make sure the filter is fully submerged in detergent while applying detergent. This
washer will only draw soap with the black soap nozzle. The Red, Yellow, Green and White nozzles will
not draw soap.
5.2.4.2. Apply detergents to the surface using long even and overlapping strokes. In general
leave the detergent on the surface for five minutes or as advised by the detergent manufacturer. DO
NOT allow the detergent to dry on the surface.
5.4.4.3. Once you have completed the soap application process you MUST flush the
detergent siphoning system after each use by placing the filter into a bucket of clean water, then
run the pressure washer in low pressure for 1-2 minutes. Failure to do this will result in blocked
siphoning tubes and filter.
Page 18
First edition -
April
201
7
