TCS-115
3. OPERATING THE TILE CUTTING SAW
Water tank
1. Remove the 45° fence and fill
the water tank with clean water
just enough to cover the diamond
blades bottom edge. No more
than 1/4 of the diamond blade
should be submerged in water.
2. When you have finished cutting,
remove the plug inside the tank
to drain the water.
Note:
The plug is also an over flow
safety device, if the unit is over
filled, water will spill out.
OPERATION
WARNING!:
DO NOT ADD CHEMICALS OR
DETERGENTS TO THE WATER.
CAUTION!
ALWAYS ALLOW THE BLADE TO REACH
FULL SPEED BEFORE PERFORMING ANY CUTTING
OPERATIONS.
On/off switch
1. Switch the tile cutting saw ON by
pushing the green (I) button.
2. Switch the tile cutting saw OFF by
pushing the red (0) button.
Note:
It is recommended to use in
conjunction with this appliance a Residual
Current Device (RCD) of rating not
exceeding 30mA.
Note:
In the event of a power failure,
accidently unplugged or turned off at the
mains power supply, you will need to push the green (I) button again to
restart the tile cutting saw.
Straight Cut
Adjust the parallel fence to the
desired width. Securely hold the
workpiece and evenly guide it with
gentle pressure into the diamond
blade. Hold the edges of the
workpiece and press down firmly to
prevent the workpiece lifting during
the cut.
Bevel Cut
Raise the 45° fence if you wish
to cut an angle or bevel on the
workpiece edge. Make the cut using
the same technique as making a
straight cut. Internal or external
bevel cuts can be made by turning
the workpiece face up or down.
Mitre Cut
With the mitre guide clipped onto
the parallel fence, adjust the mitre
angle to the desired angle. Securely
hold the mitre guide and workpiece
and evenly guide the workpiece into
the diamond blade. Make sure that
the workpiece sits firmly in the guide
before making the cut.
45
˚
22
.5
˚
0˚
0˚
22.
5˚
45
˚
22
.5
˚
0˚
0˚
22.
5˚
WARNING!:
THE DIAMOND BLADE WILL CONTINUE
TO ROTATE FOR A FEW SECONDS AFTER THE TILE
SAW HAS BEEN SWITCHED OFF. WAIT FOR THE BLADE TO
STOP BEFORE REMOVING
