5. Slide the blade cover back into
its original position.
6. Fasten the blade cover in place with
the washer and screw.
7. Refit the 45° fence.
8. Remove the knob,
bolt and washer
from the blade
guard.
9. Place the blade guard onto the blade guard bracket. Secure it
in place with bolt, washer and knob. Tighten knob sufficiently
as to allow the blade guard to rest on the table but lift when the
workpiece is pushed into the diamond blade.
Fitting the blade guard
1. Remove the screw and washer
from the blade guard bracket.
2. Position the blade guard bracket
within the water reservoir. The ‘L’ of
the bracket should point towards the
centre of the table.
3. Slide the blade guard bracket up
into the slot behind the diamond
blade, at the rear of the table.
4. While holding the blade guard
bracket upwards and in position,
fasten it to the table top with the
screw and washer.
Note:
Ensure the blade guard bracket
aligned to the centre of the diamond
blade.