6 . Place the new diamond blade on
the spindle, so that it sits centrally
aligned on the inner flange. Place
the outer flange on the spindle.
Note:
Ensure that the blades direction
of rotation corresponds to the arrow
marked on the housing.
7. Replace the blade nut. The unit
is supplied with 2 spanners, stop
the spindle from rotating with one
spanner while tightening the blade
nut with the other.
8. Replace the blade cover back into
its notch, then tighten the screw and
washer.
9. Refit the 45° fence.
4. CHANGING THE BLADE
MAINTENANCE
1. Ensure the plug is disconnected from the mains power supply.
2. Remove the 45° fence.
3. Remove the screw and washer
from the blade cover.
4. Lift the blade cover out of its notch.
5. Remove the blade nut, outer flange
and old blade from the spindle.
CAUTION!
NEVER TRY TO USE A BLADE THAT IS LARGER
THAN THE STATED CAPACITY OF THE TILE SAW. IT
MIGHT COME INTO CONTACT WITH THE BLADE GUARD
AND RISK PERSONAL INJURY OR DAMAGE TO THE TILE
SAW. THIS WILL NOT BE COVERED UNDER WARRANTY.
CAUTION!
NEVER USE A BLADE THAT IS TOO THICK TO
ALLOW THE OUTER BLADE WASHER TO ENGAGE WITH
THE FLATS ON THE SPINDLE. IT WILL PREVENT THE
BLADE SCREW FROM PROPERLY SECURING THE BLADE
ONTO THE SPINDLE.
