3
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
6
7
1. Mitre guide locking knob
2. Parallel fence
3. Mitre guide
4. 45° Fence
5. Parallel fence locking clips
6. On/Off switch
7. Guide ruler
8. Diamond blade
9. Blade guard
10. Blade guard bracket
11. Blade cover
12. Carry handle
13. Water reservoir plug
TILE CUTTING SAW
KNOW YOUR PRODUCT
1. ASSEMBLY
Prior to using the Tile cutting saw, the rubber feet, diamond blade, blade
guard and parallel fence will need to be installed.
Fitting the rubber feet
1. Insert the 4 rubber feet into the holes
on the base of the tile saw.
Fitting the diamond blade
1. Remove the 45° fence.
2. Remove the screw and washer from
the blade guard.
3. Lift the blade cover out of its notch.
4. Remove the blade nut and outer flange
from the spindle.
5. Place the diamond blade on the
spindle, so that it aligns centrally on
the inner flange. Then place the outer
flange on the spindle.
Note
:
Ensure that the blades direction of
rotation corresponds to the arrow marked
on the housing.
6. Replace the blade nut. The unit is
supplied with 2 spanners, stop the spindle
from rotating with one spanner while
tightening the blade nut with the other.
SETUP & PREPARATION
WARNING!:
ENSURE THE TOOL IS DISCONNECTED
FROM THE POWER SUPPLY BEFORE ASSEMBLY .
1
8
9
5
11
12
13
2
3
4
10
