10
SETTING OF THE SHARPENER (cont.)
5. Whilst still applying downward pressure
on the hand piece simultaneously start
rotating the depth adjustment knob anti
clockwise. Slowly continue rotating the
knob anti clockwise whilst watching the
disc get closer to the tooth of the chain.
6. When the disc enters along the face of
the tooth, make sure the disc is lowered
until it covers the full face of the tooth
but DOES NOT touch the tooth
body below.
Alternatively, you can lower the disc until
it firmly sits on top of the tooth body and
then rotate the depth adjustment knob
1
/
2
a turn clockwise to lift it slightly away
from the body. Lifting the disc away from
the body will prevent cutting into the
body or link and damaging the chain.
7. When the depth adjustment is correct, hold the depth adjustment pin in
position with one hand, using the free hand rotate the lock knob clockwise
locking the depth adjustment pin in position.
The initial set up is now complete. Fine adjustments may still need to be made
once first sharpening operation is performed.
Prior to operation, ensure you have read and understood the operating
instructions. Ensure you wear safety gear such as hearing and eye protection.
Connect the tools power-plug to a power-point.
If multiple chains are to be sharpened, it is suggested the sharpener be
turned off at the completion of each chain for a period equal to that of
sharpening the previous chain.
Turning the tool on and off
To turn the tool on, press the green ‘I’ button.
To turn the motor off, press the red ‘O’ button.
Note:
When turning on the sharpener, stand to one side of the tool. Ensure you
wear safety glasses and ear protection.
Turn on the sharpener, and slowly lower the hand-piece (1). If you notice a slight
error in your settings, turn off the tool and unplug from the power-point prior to
making any further adjustments.
Note:
A successful grind occurs when the contact between the disc and tooth is
gradual and smooth.
OPERATION
Fig. I
Lock knob
Depth
adjustment
knob
Depth Platform
Fig. H
Body
Depth
adjustment
pin
