MAINTENANCE
13
Keep the Sharpener clean and free of dust, metal debris and dirt.
Check the grinding disc before each use to make sure it isn’t damaged. Do not use a
grinding disc if it is chipped, cracked, or worn. You can check if the wheel has cracks
not visible to the human eye by hanging it up by the central hole and tapping it with a
non metal object (ie. screwdriver handle). If it is in good condition it will produce a
metallic sound. A dull sound indicates a crack or break.
Replace the grinding disc when it grinds down to a diameter of 3 inches.
Filing the chain depth
If the chain has been repeatedly sharpened, the chain depth limiting gauges (depth
gauge) may need to be filed down with a flat file (not included).
The depth of the depth gauges should be NO
more than 0.5mm below the cutters.
Always disconnect the sharpener from the power
supply prior to making any adjustments or
performing any maintenance.
Ensure replacement discs are rated at 4,800/min
or higher. Using a disc rated below the speed of
the sharpener is a hazard.
Periodically check that all nuts, bolts and other fixings are properly tightened.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
repair of the tool by an unauthorised person or mishandling or mistreatment of the
tool. This tool is designed for DIY use - use in commercial or industrial environments
will void the warranty.
DESCRIPTION OF SYMBOLS
Double insulated
V
Voltage
Regulator compliance mark
Hz
Herts
n
o
No load speed
W
Wattage
/min
Revolutions or
reciprocation per minute
Warning
~
Alternating current
!!
Depth Gauge
Cutters
