Connecting Tools To The Air Hose
1. On the other end of the air
hose, wind pipe seal tape
clockwise around the threads
and attach the female coupler.
2. Attach a male Nitto connector
to the desired air tool.
3. Retract the hood on the
female coupler and insert the
Nitto connector to attach the
tool.
Note:
Instructions for the air tool accessories can be found in the
Accessory Manual.
Disconnecting Air Tools
WARNING!
ENSURE YOU HAVE A FIRM GRIP ON
THE AIR HOSE WHEN DISCONNECTING IT FROM
THE AIR COMPRESSOR, AS PRESSURISED AIR IN
THE TANK MAY CAUSE IT TO WHIP AROUND AND
INFLICT INJURY OR DAMAGE.
1. To remove an air tool from
the unit, retract the sleeve on
the female Nitto fitting and
disconnect the air hose from
the air compressor.
2. Repeat the same procedure with the air tool and air hose.
Connecting The Air Hose to the Compressor
1. Apply pipe seal tape to the
threads to ensure a good
seal. Wind the pipe seal tape
clockwise about fittings.
2. Attach the female Nitto
connector to one end of the
air hose.
3. Pull back the sleeve on the
regulated pressure outlet of
the compressor and insert the
connector attached in step 1.
4. Release the sleeve; the Nitto coupling should click into place.
5. Check that the fitting is secure by tugging gently on the connector.
If the hose detaches, repeat steps 2 & 3, pushing the Nitto
connector firmly into the outlet.
2. ACCESSORIES
0
50
100
150
200
225
0
50
100
150
200
225
WARNING!
ENSURE THE TOOL IS TURNED OFF
AND DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.
