Connecting to the Air Compressor
The Male Nitto Connectors can be attached and left on the Blow Gun,
Air Chuck, Air Impact Wrench, Air Ratchet, & Air Chisel for quick and
easy changes between tools.
1. Wrap Thread Seal Tape
clockwise about the threads of
a Male Nitto Connector.
2. On the desired air tool, remove the black plastic cap from the Air
Inlet. If there is no cap, move on to Step 3.
3. Attach the Male Nitto
Connector to the Air Inlet of
the desired tool.
4. On the free end of the air
hose, pull back the sleeve on
the Female Coupler and insert
the Connector attached in the
previous step.
WARNING!
THE AIR IMPACT WRENCH, AIR
RATCHET, AND AIR CHISEL ARE RATED TO 90PSI.
ENSURE YOUR COMPRESSOR IS SET NO HIGHER
THAN 90PSI WHEN USING THESE TOOLS.
Attaching Sockets to the Air Impact Wrench
1. Push the desired Socket onto
the Socket Adaptor until it
clicks into place.
2. To remove the Socket, simply pull the Socket off the Socket
Adaptor on the tool.
Note:
The Air Impact Wrench should only be used with impact
sockets. Standard sockets may shatter and break.
Attaching Sockets to the Air Ratchet
1. Press the 3/8”-1/3” Adaptor
onto the Socket Retainer of
the Ratchet.
Note:
The Extension Bar can be attached in addition to the 3/8”-1/3”
Adaptor if more reach is required.
2. Push the desired Socket into the 3/8”-1/3” Adaptor until it clicks into
place.
3. To remove the Socket or Adaptor, simply pull it off the Socket
Retainer on the tool.
Note:
The Air Ratchet should only be used with impact sockets.
Standard sockets may shatter and break.
1. ASSEMBLY
SETUP & PREPARATION
WARNING!
ENSURE THE TOOL IS TURNED OFF
AND DISCONNECTED FROM THE COMPRESSOR
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.
