Control the X-MET8000 series using an iPad
An iPad or similar tablet can be used to control the X-MET8000 series trough VNC over a Wi-Fi
connection. Setup a iPad VNC connection using the following instructions.
Setup an iPad to control the X-MET8000 series
Follow these steps to install and set up a VNC client on an iPad to connect to the X-MET8000 series.
The same basics can be applied to other tablets.
The Wi-Fi and VNC Server must be set up and started on the X-MET8000 series before a VNC connection
can be established.
1.
On the iPad, purchase and install a VNC client of choice. These instructions are for Mocha VNC
client and can also be used as a guide for other VNC clients.
Follow the instructions for the selected software to install the VNC client.
2.
Start the VNC Client on the iPad. When started for the first time, add a new connection by tapping
on New.
If a connection already exists, use Menu/Add another Server to add new servers.
Once a connection is stored, use the Menu in the upper left corner to switch between Connect
and Configure.
91
X-MET8000 Series Operator’s Manual
8
