HDS2062M-N Handheld DSO & DMM 5-Using the Oscilloscope
5.6 Recall factory settings
If you want to reset the Oscilloscope to the factory settings, do the following:
1.
Press
MENU
key and the function menu appears on the right side of the screen
2.
Press the
MENU
▲
or
MENU
▼
key to select
FUNCTION
setting and three options are
visible at the bottom of the screen.
3.
Press
F1
key to select “
Recall Factor
y” to recall the factory settings.
4.
Press F2 key to select “Auto calibration”.
I
f the ambient temperature variation is up to or
larger than 5 Celsius degree, the Auto calibration function should be performed. But will not
affect the using and capability by the heat from LCD and electronic component
See the following figure 10:
figure 10: Reset the Oscilloscope
5.7 Input Connections
See figure 2.
Look at the bottom and the right of the Oscilloscope. The Oscilloscope has six signal inputs: two
safety BNC jack inputs (CH1 and CH2) for scope measurements, four safety 4-mm banana jack
inputs for Multimeter R, V and A measurements,
Isolated input allows independent floating measurements between Multimeters and Scopes.
15
