Once the file is transferred, the remote AP will be rebooted. Once the remote units are rebooted, the
site map can be updated and the File Tag will show the status of the units. If the tab matches the local
tag, the unit was updated successfully.
y
Automatic IP address Configuration
The automatic IP address configuration feature uses the last three bytes of the WAN MAC
address for the last three bytes of the IP address. For example, the WAN MAC address of
00:07:D5:01:02:03 will translate to an IP address of 10.1.2.3. fi the starting range of the automatic
IP address configuration is set to 10.128.0.0 and the WAN MAC address is 00:07:D5:01:02:03
(Basically the second byte add 128+1). The MAC address on the WAN port is from the AirLive’s
address pool of 16 million addresses. There is a small chance for duplicate MACs. However, if a
duplicate IP address is detected, the bridge site map will show this device with a red IP address.
The distributed default gateway is the first IP address in the valid range. For example: for
10.128.0.9, the default gateway is 10.128.0.1. The distribute netmask is 255.0.0.0.
14.2 Factory Default
Click the entry on the left hand navigation panel for System Administration – Factory Default to enter
this page. The “Restore” button is a fallback troubleshooting function that should only be use to reset
system to original settings.
AirLive WH-9100-MESH User’s Manual
67
