not to be co-located or operated in conjunction with any other antenna or transmitter. Installation should
be accomplished using the authorized antenna and/or cable provided with the device or available form
the manufacturer/distributor for use with this device. Changes or modifications not expressly approved
by manufacture or party responsible for this FCC compliance could void the user’s authority to operate
the equipment.
2.4.3 Sealing Antenna Connections
Once all antennas have been installed, the connection should be sealed to protect them in an exterior
harsh environment using a self amalgamating polyisobutylene tape which, over a period of hours,
adheres to itself and forms a single amalgamated rubber molding conforming to the shape of the item it
is covering. Once the tape is in place for several hours, it forms a shaped rubber molding that is
resistant to water and most solvents. It remains stable over a wide temperature range and degrades
very slowly in sunlight. Be sure that it is completely dry when applied. If you need to uninstall it after it
has sealed for 30 minutes or more, cut it away with a sharp knife.
2.4.4 Lightning Arrestor Installation
The potential for lightning damage should always be considered when setup this machine at outdoor
environment. A variety of lightning protections are available. Make sure the equipment is properly
grounded to provide low-impedance paths for lightning currents and using the lightning arrestor to
protect antennas. You can contact OvisLink to buy Lightning Arrestor and follow Appendix B to install
lightning arrestor.
2.5 Mounting Kit Setup
Step1: Choosing a suitable post for mounting kits
AirLive WH-9100-MESH User’s Manual
17
