y
Propagation Distance
This parameter relates to adjust the timing of
WLAN MAC. To make sure the radio signal can
reach to the device at other end, set the
distance based on the distance between this
bridge and furthest bridge that is connected to
it
y
RTS Threshold
This function uses for the RTS/CTS handshake boundary. When a packet size is greater than the RTS
threshold, the RTS/CTS handshaking is performed
y
Add Remote’s AP BSSID/Note for manual bridging
The BSSID corresponds to that bridge’s MAC address. The Wireless Bridging uses the BSSID
for purposes of establishing contact. You need to enter the BSSID of remote bridge, enter
hexadecimal with colons. Data entry is not case sensitive. You may also enter a note that
defines the location of the remote bridge. Then click Add to accept. The remote bridge’s BSSID
will now appear in the
Remote AP’s MAC Address
section of previous page Wireless Bridge -
General.
7.3 Wireless Bridge - Encryption
This page is used to configure static encryption keys for the wireless bridge. On this screen, you can
either select Off- No Data Encryption or Static AES Key of 128 bit. The “Key generator” function
generates a randomized encryption key of the appropriate length automatically. You can use this
function to get a randomized key number from one device and use it to all of other devices those are
on the same bridge network. The encryption key that you use on this screen must be the same for
any bridge connect to your bridging network in order for communication to occur.
AirLive WH-9100-MESH User’s Manual
40
