![background image](http://html1.mh-extra.com/html/oventrop/ovsol/ovsol_installation-manual_1662740021.webp)
20
082809
Assembling the Collector Frame
Place the collector rail on the collector top and bottom
feet and install rail where it can be lined up with the col-
lector feet bolt holes. If possible, choose the fourth hole
from the top of the verticle frame to set the bolt into the
top collector foot.
Tighten bolts.
Attach the manifold support into the first and third holes
of the vertical collector frame. Bolt the manifold support
into the collector frame with square nuts.
Bolt the bottom tube support with square nuts on the
second hole from the bottom of the vertical collector
frame; tighten bolts to avoid the bottom support from
slipping. Line up the collector clips at the bottom tube
support rail to the manifold dry well fittings for the
evacuated tubes to line up square. There may need to
be a verticle adjustment, so don’t tighten the bolt
completely until a tube has been pre-fit.
Install one vacuum tube on either end. Using corner-to-
corner measurements, ensure the collector assembly is
squared.
Install each vacuum tube from one end to the other.