![background image](http://html1.mh-extra.com/html/oval/tf1015-p11g-11-a-series/tf1015-p11g-11-a-series_instructions-manual_1662175014.webp)
S-93--E
3m
GRY: Alarm 1 output
YEL: Flow pulse output
WHT: Alarm 2 output
BRN: SUP (power +)
GRN: COM (power -)
max.
30VDC,
20mADC
max.
30VDC,
20mADC
max.
30VDC,
20mADC
24VDC±10%
GND
Shielded wire
Connect the shielded wire to GND.
(5) Flow pulse two alarm points specifications (Fig. 6.5)
(6) Flow pulse flow analog single alarm point specifications (Fig. 6.6)
GRY: Alarm 1 output
YEL: Flow pulse output
WHT: Flow analog output
BRN: SUP (power +)
GRN: COM (power -)
max.
30VDC,
20mADC
max.
30VDC,
20mADC
4 to 20mA
max.
500Ω
24VDC±10%
GND
Shielded wire
Connect the shielded wire to GND.
3m
Fig. .
CAUTION:
If "Without cable" is specified for the product, the cable shown in the wiring diagram
is not supplied with the product.
6.3 Cable Specifications
Applicable cable depends on the specifications of the th digit "Output Terminal" of the product code. Refer
to the following table.
Fig. .
●
Direct coupled cable
●
Direct coupled cable
15th digit of
product code
"Output Terminal"
specifications
※
1
Cable Specifications
State at shipment from factory
「
1
」
Cable coupled directly
[OVAL cable]
-conductor shield cable
Length: 3 m, O.D.: .3 mm
Directly coupled to the product body.
「
2
」
Connector via
interconnect cable
(with cable)
[OVAL cable]
-conductor shield cablewith connector
Length: 3 m, O.D: mm
Packed together with product body.
「
4
」
Connector terminal
(with cable)
「
3
」
Connector via
interconnect cable
(without cable)
[Recommended cable]
Manufacturer: OMRON
Model: XSF-D
□
-
□
0-F
Name: Cabled connector socket single side connector
Length: As specified by the customer
O.D.: mm
Cable is not supplied with the product.
To be prepared by the customer. The ca-
ble shown on the left is recommended.
(Purchase the cable directly from the
manufacturer.)
「
5
」
Connector terminal
(without cable)
7. OPERATION
() Verify that the process fluid conditions (such as pressure and temperature) meet the ratings specified.
() After confirming the wiring connections, turn on power and see that the flowrate reads zero.
(3) Making sure there is no leaks at tube connections, carefully open the upstream valve.
CAUTION:
1. Just after powering on, this equipment is ready for measurement. However, the optimum
accuracy is available 30 minutes after power on.
2. To safeguard the monitor against damage, avoid sharp increase in flowrate.
※
1 For the kind and shape of the output terminal, refer to the section "Explanation of Output Terminal".
Summary of Contents for TF1015-P11G-11 A Series
Page 31: ...S 193 11 E 31...