S-93--E
9
8.4 Parameter Reconfiguration
An example below shows the procedure to change Alarm setting from 00 to 00.
For display operating procedure, see Section . "Parameter Display".
Press MODE for sec.
Press MODE for sec.
Press RESET 9 times.
Press MODE for sec.
600
600
600
500
500
....................
....................
....................
....................
....................
Description
[Show the alarm setting.]
Hold the "MODE" button depressed for more than seconds. When the screen
begins to blink, remove your finger from the button.
(Write mode becomes active and the figure in the ones place blinks.)
[The figure "0" in the right-most place blinks.]
Press the "MODE" switch twice to allow the digit in the hundreds place to blink.
(Pressing the "MODE" button moves the blinking digit one place to the left).
["" in the hundreds place blinks.]
Press the "RESET" button 9 times to adjust the figure to .
(Pressing the "RESET" button increases the blinking figure.)
[The digit in the hundreds place changes to "" while blinking].
Now the reading has been changed to 00.
To save this value, hold the "MODE" button depressed for more than seconds.
When the screen begins to blink, remove your finger from the button. (The
setting is saved and you exit the write mode.)
If you want to exit the write mode without completing the setting, hold the
"RESET" button depressed for more than seconds. When the screen begins
to blink, remove your finger from the button. (You exit the write mode without
saving any value.)
[The indicator stops blinking and stays on.]
Now the setup process is complete.
Summary of Contents for TF1015-P11G-11 A Series
Page 31: ...S 193 11 E 31...