Maintenance - continued
Windows, Doors, Vents and Locks
Keep moving parts, hinges and latches adjusted and maintained. Lubricate with light oil at least
once a year.
Check and tighten the screws holding the window in place as required. Clean screens by gently
wiping with a damp cloth or soft flat brush. Note all screens are removable.
Inspect the sealants around doors and windows every three months. See
Sealant renewal section.
Lubricate locksets in doors and exterior storage compartments at least annually with powdered
graphite. If the trailer is located at a beach or is exposed to salt air, more frequent lubrication may
be required.
Sealant Renewal
This section outlines the procedures you must follow to maintain the weatherproof integrity of
your trailer. Leak damage caused by failure to inspect and maintain the roof, vents, TV / satellite
antenna and moldings seals may affect your warranty coverage.
The adhesives and sealants used in the construction of your trailer were developed to remain
waterproof under sustained effects of weather and vibration. However, even the finest materials will
eventually dry out and lose their effectiveness.
Your dealer can perform the resealing inspection and work for you. Your dealer also has current
information on sealants used in your trailer, and can recommend the appropriate sealants for you if
you prefer to do the work yourself. Always use recommended sealants.
▲
Note
Failure to seal could cause serious damage and may affect your warranty coverage.
Door, Window, Roof Component and Molding Resealing
Inspect the sealants around windows, floors, joints and doors at least every three months. Also
inspect roof vents, and other roof components, molding at front and rear cap, and perimeter
molding. If any of the following defects are evident during inspection, the affected areas must be
resealed.
1. Sealant cracked or peeling.
2. Void or missing sealant.
If you find any of the above defects:
1. Clean all areas to be resealed with an appropriate cleaner and clean rags.
2. Make sure that all areas to be resealed are absolutely dry before new sealant is
applied.
▲
Note
Do not seal the bottom flanges of windows and doors. Special gaps in the sealant have
been intentionally left in the bottom flange to provide drainage.
83
Summary of Contents for 2013 Creek Side
Page 1: ......
