System Components
Hoses and Fittings
The hoses used in your propane system meet stringent requirements, and are rated to withstand
many times the pressures encountered in the system. Check the hoses for weather checking or
signs of deterioration every time you have a Propane cylinder filled or serviced. When you replace
hoses, be sure that replacements are the same size, properly rated and approved for RV use.
The fitting at the end of the Propane high pressure hose is one with which you will most often come
into contact with - you will handle it many times during your trailer ownership to service and fill your
Propane cylinders. Turn it to the right to tighten, turn left to loosen. It does not require any type of
pipe sealant. If it ever leaks or cannot be reasonably tightened without excess force, replace the
complete hose assembly and /or have the cylinder valve checked and serviced.
This fitting contains an excess flow valve to restrict Propane flow if the flow exceeds the valve
design output. Note that it is not designed to detect a leak or to totally shut down the system if
a failure occurs.
Propane Regulator
The two-stage regulator produces approximately 11 inches of water column (less than 0.5 psi) to
serve your appliances. Be sure the regulator vent stays clean and free from obstructions.
The regulator is mounted so that the vent is facing downward and is protected by a cover. Be sure
the cover is on at all times. If the vent becomes clogged, it can be cleaned with a toothbrush. If
corrosion is evident, contact a qualified Propane service technician for assistance.
The regulator incorporates a feature known as "automatic changeover." Propane systems used in
trailers are designed to operate from two separate Propane cylinders, and the auto changeover
allows continuous Propane supply, when one cylinder runs out.
In a dual cylinder system you start out with two full cylinders of Propane. Position the cylinder
selector lever all the way toward the cylinder that you want to use first, this will be your "service"
cylinder. The other cylinder will be your "reserve" cylinder. Make sure all appliances and pilot lights
are turned off. Open both cylinder valves and wait until the regulator indicator turns green before
attempting to light an appliance. A green regulator indicator means that the system is pressurized
with Propane.
When the service cylinder runs out of propane the regulator indicator will turn red. This means that
you are drawing Propane from the "reserve" cylinder, making it the "service" cylinder.
▲
Warning
Your trailer has been equipped with Propane containers that feature an overfill protection
(OPD) NFPA 58 (Propane Code) states that these portable cylinders shall not be filled
without this device.
Do not under any circumstances use an older non-OPD cylinder. Inadvertently overfilling
of the pre-OPD cylinders can result in uncontrolled Propane flow that in unvented
surroundings can cause fire and/or explosion.
61
Summary of Contents for 2013 Creek Side
Page 1: ......
