Living with your Trailer - continued
Slide out Override
Manual Operation of the Slide out Mechanism
1. It is necessary to disconnect 12 volt power from the slide out motor. The
12 volt power can be disconnect by turning the disconnect switch to the off
position or by disconnecting the battery cables from the batteries
2. Be certain that the RV is leveled properly and that there is plenty of clearance
for your room to safely extend or retract.
3. Remove any other potential obstructions to room movement.
4. Locate the slide out system motor, which will be on the closest ram
towards the front of your trailer.
Locate the manual override hex nut. (On back of slide motor).
6. Utilize a 5/8 socket to turn manual override.
Maintenance
Monthly
1. Inspect room weather seal for stiffness. Treat with silicone if the rubber
appears or feels stiff.
2. Inspect all fasteners attaching room mounts to the ends of the arm tubes
for signs of looseness. Tighten as necessary.
Semi-Annually
1. Clean gear rack and tube of any debris.
2. Be certain that the RV is leveled properly and that there is plenty of room to extend it.
It is not recommended to leave unit extended when not in use, as they tend to catch dirt and grit, which will be
detrimental to the gears and gear rack of your slide out system.
Annually
1 Inspect electrical connections at the motor for corrosion and tightness.
Clean, replace or tighten if necessary.
35
Summary of Contents for 2013 Creek Side
Page 1: ......
