Assembly
900-0123-01-00 Rev
A
23
Mounting on the Inverter
IMPORTANT:
The Radian inverter and GSLC are intended for indoor use only. Ensure that the
mounting surface is strong enough to support the full weight of the Radian
inverter/charger and the GSLC. If in doubt, use a ¾“ sheet of plywood to strengthen the
wall surface.
Figure
18
Mounting the GSLC
To mount the GSLC to the Radian inverter:
1.
Install the Radian inverter onto the mounting bracket as
instructed in the Radian Series Inverter/Charger
Installation Manual.
2.
Back out bottom screw(s) approximately ¼ inch (0.6 cm) to
3/16 in (0.5 cm).
3.
Remove the front and interior covers from the GSLC if
necessary, as described on page 16.
4.
Align the GSLC along the bottom of the inverter and slide
the mounting screws onto the keyhole slots.
5.
Hanging the GSLC from the screws and holding it flush
against the bottom of the inverter, mark the spots for the
holes for the mounting feet. These are located in the rear
of the GSLC and are marked below.
6.
If using wall anchors (included): Remove the GSLC and
drill leader holes for the hardware to be used to secure the
GSLC to the surface. Install the wall anchors. If mounting
on a solid surface like plywood, this step can be skipped.
Bottom Screws
Mounting Feet
Holes (x4)
14”
(35.6 cm)
12.5”
(31.8 cm)
Continued on the next page....
Keyhole Slots
Keyhole Slots
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
