![background image](http://html1.mh-extra.com/html/outback-power/gs-load-center-series/gs-load-center-series_installation-manual_1660789021.webp)
Assembly
900-0123-01-00 Rev
A
19
Installing Inverter Positive Bus Bars
Figure 14
Inverter Bus Bars
3. Mount the narrower bus bar and its top
piece to the top terminal of the
disconnect on the left. Tighten to the
value shown in Table 2 on page 17.
2.
The GSLC’s hardware kit contains a top bar which
attaches to the narrower bus bar. Attach these two
bars together using a 5/16” flat washer, a 5/16” lock
washer, and an M8 nut (included in hardware kit).
Tighten to the value shown in Table 2 on page 17.
To assemble the Inverter Positive Bus Bars:
1. Attach the wider of the two bus bars to
the top terminal of the disconnect on
the right, using the stud and hardware
on the back of the disconnect. Tighten
the nuts to the values shown in Table 2
on page 17.
The GSLC parts kit contains two bus bars which attach to
the tops of the DC disconnects. These bus bars make the
connections with the Radian inverter’s positive DC
terminals. Although they have similar shapes, the bus
bars are not interchangeable.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor