OUMAN EH-203
NET MEASUREMENT
OUMAN EH-203
Directions for entering the
maintenance mode are on page 21.
Net measurement
Outdr tmp meas
H1 Room meas.
H2 Room meas.
Wind measure
Sun measure
DH Energy MWh
Watr consm. m3
OK.
OK.
Setting limits:
-
+
Press
Press the
or
button to set the limit and confirm
by pressing
Comp/Meas. data
Min/
m/s
Max/
m/s
0.0
10.0
Comp/ Meas. data
Min/
lx
Max/
lx
0
9000
By using the
button to browse, you can see which measurements can
be read from the net.
Move the cursor to the measurement you want and
press
If you want to select an serial interface for the
measurement in question, move the cursor to Yes
net and press
The
character indicates that
the measurement information is read from the net.
OK
OK
.
.
Browsing the net measurements:
You must set the compensation limits for wind and sun measurements.
The minimum indicates when compensation begins and the maximum
indicates when compensation is at a maximum value. Set the limits for
wind measurement as wind speed (m/s) and for sun measurement as
amount of light (lx).
Outdr tmp meas
No net
Yes net
Setting net measurements:
Setting wind or sun measurements (net):
Attention! Set wind and sun compensation in "Settings" (see page 6-7).
Special mainten.
Rstore settings
Settings
Meas. 6 setting
Dig1 selection
Dig2 selection
Dig3 selection
Enrgy meter
LON initaliz
Net measurement
TextMessageSett.
Curve type
Regul.Circ.Name
Press the
button to move the cursor to
.
Press
"Net measurement”
OK
.
Ouman EH-203 has an LON-200, RS-485 and MODBUS-200 bus adapter
cards as an optional equipment.
In this special maintenance mode you can select which measurement
informati is to be read from the net.
If you selected to read wind or sun measurements from the net,
you must set the compensation area in this mode.
36
