ESC - press to return to the previous display
Info button - gives operating instructions
Browse button - moves the cursor up and down
ESC
Group select button - not in use in EH201/L
8
OUMAN EH-203
OUMAN EH-203
OUMAN EH-201/L
OUMAN EH-201/L
Ajan asetus
Explanation:
Range:
Factory
Settings:
Settings:
Attention!
Additional information about settings
When the temperature of measurement 10
drops to the set limit, the regulator causes
relay 1 to turn the burner on (see p. 26).
When the temperature of measurement 10
drops to the set limit, the regulator causes
relay 2 to switch on the heating resistor (p. 28)
During full effect geothermal heating th
When the temperature of accumulator lower
part drops to this min. limit the regulator
switched the compressor on d
.
Pump summer stop: Outdoor temperature at
which the regulator stops the pump. During
connection and installation, the maintenance
person decides whether to stop the circuit
pump and whether the valve will continue
regulating or whether it will close (see
mainten. mode page 26).
e
regulator controls the compressor or the
heating resistor according to the accumulator
temperature set by the user.
During limited effect geothermal heating the
regulator controls the compressor and heating
resistor according to the accumulator upper
part temperature set by the user. The regulator
also controls the compressor according to the
temperature needed in the heating network.
uring limited
effect geothermal heating
Temperature of measurement 11 when relay 1
is to be activated.
5...95 °C
5...95 °C
5...50 °C
5...55°C
5...75 °C
30...55 °C
0...100 °C
Burner ON
70 °C
50 °C
19 °C
55°C
55°C
35°C
55°C
Select relay 1 for
burner control.
Select relay 2 for
heating resistor
control.
Pump stop appears
in place of the valve
summer close setting
if pump summer stop
has been selected in
the relay 1 control
mode.
El.Heater ON
Pump stop
Geothermal heating
accumulator's temp.
Geothermal heating
accumulator's
upper part temp.
Geothermal heating
accumulator's
lower part min temp.
Relay 1 temperat.
limit
"GeothHeatAcc"
"GeothH.UpPart"
"GeothH.LowMin"
"R1 temp lim."
The setting appears
if "GeothHeatFull"
has been selected
in "Relay 1 control"
selection (p. 26).
The settings
appear if
"GeothHeatPart"
has been selected
in "Relay 1 control"
selection (p. 26)
The function is taken
into use in the
maintenance mode,
in the relay 1 control
mode (p. 26).
SETTINGS ACCORDING TO RELAY CONTROL MODES (see pages 26 - 28)
H1
SETTINGS
KEYWORDS:
H1 Settings
H1
Settings
Autumn
dry=
Room
temp.=
Temp
drop(w)=
Min.
limit=
Max.
limit=
Room
compens.=
Pre-increase=
21.5
15
70
4
0
2
/
/
/
/
/
/
/
0