OUMAN EH-201/L
MEASUREMENT 3 SETTING
OUMAN EH-201/L
Directions for entering the
maintenance mode are on page 21.
Erikoishuolto
Aset.palautus
Asetusarvot
Mitt. asetukset
Meas. 3 setting
H1 Room temp
Wind meas.
Sun meas.
Measure 3
Not connected
Comp/Meas.data
Min /
30%
Max /
70%
More information about sun and wind sensor connection on the next
page
Labeling measurement 3 using the text editor:
The factory setting for free measurement is
labelled "Meas. 3".
Relabeling is shown on page 9.
Press
Press the
or
button to set a limit and
press
to confirm.
OK
.
+
OK
-
The
character indicates which measurement has been chosen for
measurement 3.
Selecting measurement 3:
Setting limits for the wind or sun sensor measurement message:
You must set compensation limits for wind or sun measurements.
The minimum indicates where in the transmitter's measurement area
the compensation begins and the maximum indicates at which
measurement area the compensation is at maximum value.
Name change
Measure 3
Give new label
Special mainten.
Rstore settings
Settings
Meas. 3 setting
Dig1 selection
In this special maintenance mode, measurement 3 can be
changed to
or wind or sun
compensation measurement. The H1 room compensation is a factory
setting. Free temperature measurement is labeled "Meas. 3”. This label
can be changed
just a free temperature measurement
using the text editor.
Press the
button to move the cursor to what you want to connect
to measurement 3. Press
OK
.
Press the
button to move the cursor to "Meas. 3 setting". Press
OK
.
ESC - press to return to the previous display
Info button - gives operating instructions
Browse button - moves the cursor up and down
ESC
Group select button - not in use in EH201/L
31