Otto Bock 3B1-2/3B1-2-ST, Instructions For Use Manual

Page: 109 / 116

Status LED Charging status indicat­
or (5 LEDs)
Error Resolution
LED 2 and 4 are lit up Charger excess temperat­
ure
LED 1, 3 and 5 are lit up Excessively high or low
temperature of the pros­
thesis
Check whether the spe­
cified ambient conditions for
charging the battery are met
(see Page 103). The LED
ring is lit up
yellow
LED 3 is lit up The prosthesis is not being
charged
Distance between battery
charger and receiver of the
charging unit too great. Connection may be
improved by reducing the
distance between the char­
ger and receiver of the char­
ging unit.
The LED
ring is lit up
green
The battery charger is
functional but not connec­
ted to the receiver, or the
distance between the bat­
tery charger and receiver
of the charging unit is too
great. Connect the battery charger
or reduce the distance
between the charger and
the receiver of the charging
unit on the prosthesis.
The LED
ring is flash­
ing red
The prosthesis is not being
charged
Defective battery charger. Reset the error by discon­
necting and connecting the
power supply.
If the error persists, the bat­
tery charger and power sup­
ply must be inspected by an
authorised Ottobock Ser­
vice Center.
17.2.3 Error messages while establishing a connection with the cockpit app
Error message Cause Correction
Component was connec­
ted to another device.
Establish connection? The component was connec­
ted to another device To disconnect the original connection, tap the " OK "
button.
If the original connection is not to be disconnected,
tap the "
Cancel " button.
Mode change failed
An attempt was made to
switch to a different MyMode
while the component was in
motion (e. g. while walking) For safety reasons, switching MyModes is only per­
mitted when components are at rest, e. g. while
standing or sitting.
A current connection to the
component was interrupted Check the following points:
•
Distance from the component to the device
• Charge level of the component's battery
• Bluetooth of the component switched on?
(Switching Bluetooth of the component on/off)
• Hold the component with the sole of the foot
facing up to make the component "visible" for
2 minutes.
• If multiple components were stored, was the
correct component selected?
109
Appendices