www.oster.com
www.oster.com
7
8
HOW TO JUICE USING YOUR JUICE EXTRACTOR
OPERATING INSTRUCTIONS
1. Prepare your fruits and vegetables by washing them.
thoroughly and peeling off those that need the skin removed.
2. Prepare the fruits and vegetables by cutting them into smaller
pieces to ensure they will fit in the chute.
3. Make sure your juice extractor is properly assembled. Please
follow the instructions from the section “Before Using Your
Juice Extractor.”
4. Ensure the juice extractor and its accessories are clean by
following the cleaning and maintenance section of this
manual.
5. Place the jar or any other container/glass you may wish to use
to collect the juice under the spout and make sure the pulp
collector is in place prior to begin juicing. Do not allow the
pulp collector container to overfill as this may cause the unit
to stall.
6. Plug the power cord into an electrical outlet and turn the unit
on “I”.
7. Once the juicer is on, place the fruits and vegetables on the
food chute and use the food pusher slowly to drive them
down. In order to extract the maximum amount of juice, it is
important to push the food pusher slowly.
8. The juice extractor will separate the juice and the pulp in the
jar and pulp collector while you are juicing.
NOTE:
Both the pulp container as well as the jar can be emptied
during juicing by turning the juice extractor off “O.” Make sure to
place both containers back in place before you resume juicing.
NEVER USE HAND OR FINGERS TO PUSH FOOD DOWN THE
FOOD CHUTE OR TO CLEAR THE FOOD CHUTE. ALWAYS USE
THE FOOD PUSHER PROVIDED.
INSTRUCTIONS FOR USE
BEFORE USING YOUR JUICE EXTRACTOR
Follow the assembling instructions listed below before using your
Oster® Juice Extractor:
• Before you start assembling your juice
extractor, make sure it is unplugged and it
is placed on a dry and level surface
• Place filter basket on top of the motor base
(Figure 1)
• Place the stainless steel filter on top of the
filter basket pushing down and turning it
until it fits into the grooves of the motor
shaft (Figure 2)
• Place juicer cover/lid on top of the filter
basket (Figure 3)
• Raise the safety locking arms, then lower
them to securely fit into the grooves in the
lid and then firmly press lower part of the
locking arms into the unit ensuring they
lock the lid into the unit (Figure 4)
• Place the pulp container into position by
tilting it slightly (Figure 5)
Important: Make sure Pulp Container edge
is underneath the lip of the basket
• Place the 20 oz. jar under the spout located
on the right hand side of the juicer by
tilting it slightly. Other jars or glasses can
be used as well (Figure 6)
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
3157 series_13ESM1.indd 7-8
9/27/13 3:03 PM
