SECTION 3 - CHASSIS & TURNTABLE
3-58
– JLG Lift –
3120740
9.
Retaining ring (11) installed into the groove provided in
the Output Shaft (1A). This Retaining Ring (1l) should
never be reused in a repair or rebuild.
EYE PROTECTION SHOULD BE WORN DURING THIS PROCEDURE.
10.
A soft metal punch should be used to insure that this
Retaining Ring (11) is completely seated in the groove of
the Output Shaft (1A).
EYE PROTECTION SHOULD BE WORN DURING THIS PROCEDURE.
11.
Upon completion of Step 10, rap the internal end of the
Output Shaft (1A) twice with a piece of soft metal rod.
This will release the preload which was on the Bearings.
12.
If the assembly is not going to be used right away, it
should be oiled and covered to help prevent rusting.
Carrier Sub-Assembly
1.
Apply a coat of grease or petroleum jelly to Cluster Gear
bore.
2.
Place Needle Rollers into Cluster Gear bore.
Go to
Discount-Equipment.com
to
order your
parts
