SECTION 3 - CHASSIS & TURNTABLE
3120740
– JLG Lift –
3-57
3.
Invert Hub (1G) and press Bearing Cup (1E) into inter-
counterbore of housing (1G).
4.
Returning the Hub (1G) to locate on the large diameter
end, the Output Shaft (1A) is carefully installed into the
Hub (1G).
5.
The Shaft Seal (1B) is installed over the Output Shaft (1A)
and into the counterbore of the Hub (1G). Care should
be taken to insure the Seal (1B) is being correctly
installed (smooth face UP and located just flush with the
counterbore face).
6.
The Bearing Cone (1F) is an interference fit and has to be
pressed or tapped on.
7.
Pipe Plugs (1J & 1K) should be checked and/or installed
at this time in the assembly.
8.
Bearing Spacer (1H) is installed around the Output Shaft
(1A) and locates on Bearing Cone (1F).
Go to
Discount-Equipment.com
to
order your
parts
