
56
In this page it is possible to determine the Midi Out channel number for each section. It is also possible
to set the Program Change On/Off , the Control Change On/Off and Local Control On/Off.
By pressing the midi button a fourth time it is possible to set the Local Control for the disk drive unit.
This will enable you to play songs using sounds from a second sound keyboard and save polyphony in
the GT2600.
To store the new Midi setting, press the SET button.
CONNECTIONS
HEADPHONES
The headphone can be plugged in for private practice. The socket is located at the front of the
instrument below the left part of the lower keyboard and allows you to play without disturbing and
being disturbed by outside noise.
MAINS
This is the main connection to power. Connect the power cord to the main inlet. Note the 120V - 240V
the Voltage selector. Make always sure that it matches the locale voltage.
LINE IN
The two inputs (Left and Right) are used to send the audio signal of an external sound source (keyboard
or sound module) to the same amplifier when you are running out of input sockets in your mixer.
LINE OUT
The two outputs (Left and Right) and they are used to send the audio signal out an external amplifier,
mixer console or recording equipment. To connect the instrument to an external amplification system
use the Output 2 and connect both Left and Right outputs. To use a mono system, connect one jack to
the L/R output.
MIDI CONNECTIONS
The Midi IN 2 (DISK) connector receives the Midi data from an external Midi device. Using MIDI IN
2 it is possible to send midi information to the first set of Midi Channels that the instrument provides
without effecting the operations in the panel.
The Midi IN 1 (KEYB.) connector also receives the Midi data from an external Midi device. Using
MIDI IN 1 it is possible to send midi information to the second set of Midi Channels that the
instrument provides without affecting the operations of the disk/song section.
The Midi THRU connector retransmits any data from the Midi IN directly to other Midi devices.
The Midi OUT connector transmits Midi data generated by the instrument to other Midi instruments
and it is possible to configure it to send out Song notes or keyboard notes.
BASS PEDALBOARD
This is the connection for the 13 notes bass pedalboard.
SWITCH PEDAL
This is the connection for the 2 switch pedals that can be programmed to your requirements.