Orion FLEX HPA, Manual

Page: 45 / 166

Orion Machine Manual
Revision 3.0 Flex Stretchwrapper
15 February 2016 System Operation
Page 3-11
CARRIAGE DOWN
SPEED
Press this button to change the speed of the carriage on the downward move, in
terms of percentage. Min - 5% Max - 100%
WRAP BOTTOM FIRST
Press this button to select the Wrap Bottom First wrap sequence. When selected, the
wrapper will apply the bottom wraps first. When complete, the Carriage will travel
to the top of the load and apply the top wraps. When complete, the Carriage will
travel to the bottom and complete the cycle.
WRAP TOP FIRST
Press this button to select the Wrap Top First wrap sequence. When selected, the
Carriage will immediately travel to the top of the load and apply the top wraps.
When complete, the Carriage will travel to the bottom, apply the bottom wraps, and
complete the cycle.
WRAP UP ONLY
Press this button to wrap up only. The machine will wrap to the top, then stop the
cycle.
LOW SPEED SELECTED
Press this button to toggle between High Speed and
Low Speed operation. When High Speed is selected,
the Main Drive will travel at the predefined High
Speed value during the wrap cycle. When Low
Speed is selected, the Main Drive will travel at the
predefined Low Speed value during the wrap cycle.
HIGH SPEED
SELECTED
UNSTABLE LOAD
DISABLED
Press this button to enable or disable the Unstable
Load wrap cycle. When enabled, the Main Drive will
travel at Low Speed until the wrapper has completed
one top wrap. After one top wrap is completed, the
Main Drive will travel at High Speed for the remain-
der of the cycle. If Low Speed is selected, the Main
Drive will travel at Low Speed for the entire cycle.
UNSTABLE LOAD
ENABLED
AUTOHEIGHT
DISABLED
Press this button to enable or disable the Autoheight
photoeye. When enabled, the Carriage will travel up,
during the wrap cycle, until the Autoheight photoeye
no longer sees a load. It will continue to travel until
the Autoheight Delay time is complete. When dis-
abled, the Carriage will travel up, during the wrap
cycle, until it reaches the Top Limit sensor.
AUTOHEIGHT
ENABLED
FILM FAULT DISABLED
Press this button to enable or disable the End of Roll
or Broken Film fault. When disabled, the wrap cycle
will continue even if the film has broken or there is
no film left on the roll.
FILM FAULT ENABLED
Table 3-6. The Wrap Settings Screen Button Descriptions (Continued)
STATE 1 DESCRIPTION STATE 2