Orion FLEX HPA, Manual

Page: 107 / 166

Orion Machine Manual
Revision 3.0 Flex Stretchwrapper
15 February 2016 Troubleshooting
Page 4-17
Film Cutter Not Cutting Film
Load not positioned properly.
Look for underhung loads, or loads that
are not centered on the table or in the
proper wrap zone (RT only). The rear side
of the load must be in line with the pallet
stop for the clamp, brush and cutter to
work properly.
Re-center the load to the proper position
on the table (or wrap zone on RT
machines).
Brush extend timer at the touch-
screen is incorrect for the applica-
tion.
Look for the arm to activate smoothly, but
at the wrong time.
Observe the factory preset value on the
settings screen. Re-adjust the brush extend
timer as needed.
Cutter wire is loose.
Check for wavy or bent cutter wire. The
wire expands as it is heated. If the wire is
not straight and under tension, then it will
not be in the correct position to cut prop-
erly.
If wire is loose or bent, repair or replace
the wire.
Blown Fuse.
Locate hot wire control fuse. Remove fuse
and check continuity.
Bad Fuse? Replace with correct type.
Table 4-1. Troubleshooting Chart (Continued)
PROBLEM POSSIBLE CAUSE SOLUTION