Orion FLEX HPA, Manual

Page: 82 / 166

Machine Manual Orion
Flex Stretchwrapper Revision 3.0
System Operation 15 February 2016
Page 3-48
Information & Alarm Messages
The message and alarm displays are divided into two separate charts in this section.
• Message Displays - Various non-critical status messages
• Alarm Displays - Operation critical alarms/faults
Message Displays
The messages in this section are the various non-critical status messages. These messages
are for informational purposes. For critical alarms, see “Alarm Displays” on page 3 - 52.
Note:
Not all messages in this list are applicable to your machine. The
alarm messages on you machine may vary based on machine
options.
Table 3-33. The Information and Alarm Displays
MESSAGE DESCRIPTION CORRECTION
MACHINE SETUP
REQUIRED - SELECT
MACHINE OPTIONS
The machine setup parameters are not set.
See “Machine Setup Screen” on
page 3 - 26.
APPLYING TOP
WRAPS The machine is currently applying the top wraps.
This is for informational pur-
poses only. No correction neces-
sary.
END OF FILM ROLL
OR BROKEN FILM
The film has broken or the roll ran out.
Re-load a new roll if out. If bro-
ken, monitor the film. Replace
roll if problem persists. See trou-
bleshooting chart for broken film
troubleshooting tips.
CYCLE ENDING
The cycle is ending.
This is for informational pur-
poses only. No correction neces-
sary.
CYCLE PAUSED
The cycle is paused.
Resume, when ready. Press the
resume button on the Run
screen.
E-STOP PRESSED
The E-stop button is currently pressed.
Release the E-stop button to
allow operation. Press Start to
reset control power, then press
and hold start for the amount of
time set up in the parameters.