- 5 -
For
AR
(
LSD
)
/NX
Series driver only
1.
Set the driver pulse input mode to 1 pulse mode.
See the driver user manual about how to set.
2.
Set the driver interface voltage switch to 5 V
∗
The power must be off while setting.
3.
Set the driver interface logic switch as you desire
∗
Connections differ according to the switch settings as below.
* The power must be off while setting.
4.
Connect Pulse/Direction and CON signals
14:PLS-/CW-
15:DIR-/CCW-
1:PLS+/CW+
2:DIR+/CCW+
Pin assignment for Driver connector (26 pins)
6:GND
13:5/24 V OUT
7:CON
•
Pulse (PLS)/Direction (DIR) signals
SCX11
DIR-
DIR+
PLS-
PLS+
PLS+/CW +
PLS-/CW -
DIR+/CCW +
DIR-/CCW -
Driver
14
2
15
1
31
32
35
36
•
Current ON (CON) signal
a. Sink Logic
SCX11
C-ON
IN-COM
5/24 V OUT
CON
Driver
5 VDC
GND
13
7
22
23
b. Source Logic
SCX11
C-ON
IN-COM
CON
GND
Driver
5 VDC
GND
6
7
22
23
5.
Connect the 24 VDC Power supply
Strip the cable insulation by 10mm. Push down the spring (orange) of the connector with the
flat-tip screwdriver to open a terminal point, and insert the cable.