7 Setting
－
41
－
7.2 Pulse-input
mode
Either the 2-pulse or 1-pulse input
mode may be selected in accordance
with the controller used.
When the actuator is to be controlled
through 2-pulse signal input via the
CW pulse signal and CCW pulse
signal, set the pulse-input mode select
switch to “2P.”
When the actuator is to be controlled
through the PLS (pulse) and the DIR.
(rotating-direction), set the pulse-input
mode select switch to “1P.”
Pulse-input mode select switch
Function select switch (SW3)
Not used.
Note
•
Be sure to shut off the power before using the pulse-input mode select
switch. The new pulse input mode takes effect when the power is turned
on again.
•
The factory setting of the pulse input mode depends on the destination
country. Check the pulse input mode setting in accordance with the
pulse mode in the controller used.
Summary of Contents for ASD10A-K
Page 51: ......
